136
If the
Reset Lock
is enabled, it is not possible to perform the
Reset
of system (see
6.18. Activation / deactivation of item functions
).
Temporary Reset of Master and Installer Passwords
If you have forgotten the master password or the installer password, you will not
be able to enter programming mode and gain access to the center's settings/
operations. If this occurs, there is a temporary reset for these passwords following
the step below:
1. With the alarm center on, press the wireless device registration key for
approximately 15 seconds, when the LED ashes again the center will enter the
temporary reset mode for 1 minute. During this time the master password will be
1234
and the installer password will be
9090
.
During this time it will be possible to enter programming mode and change the
master password and/or the installer password (see topic
6.8. Passwords
). If
nothing is done during this period, the passwords will return to the same previously
programmed values.
Reset by programming mode
The
Reset by programming mode
, erases all programming done in your alarm
center and cancels the reporting of pending events.”
To program this function, type:
0000
+
Enter Enter
+
Note:
this command does not erase the wireless devices registered in the alarm
center or the editable messages.
If you want to perform a single command to erase all the settings of the alarm
center, including wireless devices registered and editable messages, type:
9999
+
Enter Enter
+
Attention: this command will return the alarm center to the factory standard, so
even the keyboard used to perform the command will lose its registration, and all
programming must be redone.
To Next Page
Loading...
