66
6.8. Passwords
Attention: » The alarm center to be operated/congured requires passwords,
being some passwords are created through programming mode
(secondary passwords, duress) and the installer password has the
9090
factory standard . In case of remote access password and master
password for increased security are random passwords which are
available on the QR Code label together with the MAC address of
the alarm center.
» Before you change the installer password or the master password,
make sure to have the new password well stored or noted, because
after exiting the programming mode, you will only be able to access
this mode again through the new password. If the password is
forgotten, see
6.20. System reset section.
Note: » For security reasons, do not reveal the master password to third parties.
»
If the master password is forgotten, perform the
System reset procedure with
the installer password
. This reset deletes all alarm center settings except
wireless devices and editable messages.
»
Alarm center cannot contain repeated passwords between users, including
Master User, Installer and Remote Access, and because of this it does not allow
the programming of repeated passwords.
»
If the center is operating with a 4-digit password, no password can be equal
to the rst 4 digits of the remote access password.
»
If the alarm center's system is reset, it will no longer use the random passwords
that are linked together with the QR code label pasted inside the alarm center
and will use the
1234
password as the master password and the
878787
password as remote access until they are changed again.
The alarm center has 96 secondary passwords and can be programmed for up
to 16 partitions, that is, it would be similar to divide the alarm center in 16 and
command by one or more keyboards or remote applications.
With the installer password, you have access to the programming mode and it is
possible to change the installer and computer/remote password, as well as perform
the settings for the alarm center, but it is not allowed to activate and deactivate the
alarm center, change the master password or the secondary passwords.
Using the master password, you can change your own password, program and/or
change the secondary passwords, enable or disable the entire alarm center or a
specic partition.
To Next Page
Loading...
