65
Note:
if 00 is programmed, error beep will be emitted and the setting will not be
changed.
To edit/view the programmed value, type:
+
4
+
Enter Enter1
After changing the congured value, press the
Enter
key. If you only want to view
the setting, press the
Exit
key and no programming will be changed.
6.7. Update
AMT 8000 alarm center has remote software updates, and if new software versions
are available, it is not necessary to use recorders or connect to computers to be
updated by downloading the new version through Ethernet or Wi-Fi connections.
When the version update is performed, the registration of the wireless devices or
saved settings will not be lost.
To download/check a new version, type:
9922
+
Enter
+
Enter
If there is a version to download, the
Download Wait
information will be displayed
and it will start, which will take about 3 to 5 minutes (variable according to the
connection used). If the alarm center does not have a version for download will be
shown
Alarm center is already updated.
After the download time has passed, access the programming mode again and
type in:
9933
+
Enter
+
Enter
The new version that was downloaded will be installed and will not be lost records
and programming of the alarm center. To check the software version of the alarm
center, access
Menu
and with the arrow keys access
Version of the alarm center
to be displayed.
Note: It is necessary that the alarm center is connected to the Internet through the
Ethernet or Wi-Fi connection, present in the center and described in the following
commands/information its settings. It is not possible to download/update software
through the GPRS connection due to the connection download rate and excessive
consumption of the package used.
To Next Page
Loading...
