Intelbras AMT 8000 - Page 64

64
» In case of partitioned system and with siren without partition dened for
it, beeping will take place on the common siren, if the system does not
have common siren, beeping will not have activation/deactivation for this
partition and neither will beeping of the other sirens for this partition in
case of triggering.
Enabling the siren beep in the activation/deactivation on a specic
partition
Select to which partitions the siren beep will be emitted in the activation/deactivation
of center when the same is partitioned by customizing the registered siren for each
partition. On activation, the siren will emit 1 beep and on deactivation, the siren
will emit 2 beeps. If any trouble is detected and the Indication of troubles by siren
function is enabled, the siren will emit 1 long beep on activation and 2 long beeps
on deactivation.
To program this function, type:
+
Group of partitions224
+
Enter
0 or 1
+
Enter
After entering the command, using the XAT 8000 keyboard, mark which partitions
will have the siren beep active, using the numbers on the keyboard to leave a mark
on the partition. Select 0 for partition group 1 to 10 and 1 for partition 11 to 16.
After changing the congured value, press the Enter key. If you only want to view
the setting, press the Back/Exit key and no programming will be changed.
Siren Time
Siren time leaves the factory programmed for 5 minutes. This is the time that the
siren will be turned on/beeping after a violation/intrusion in any active partition/
zone occurs and can be changed to a time between 01 to 99 minutes.
To program this function, type:
+
4
+
Enter
01 to 99
minutes
+
Enter1 Siren Time