Intelbras AMT 8000 - Page 142

142
Note: for XAS 8000 and TX 8000 the Sensitivity, Sensor LED andOperation
Mode settings are allowed by the unit, but only the LED conguration is
accepted by XAS 8000 and TX 8000.
» Wireless sensor testing
Enter + 52 + Enter + Activate sensor
» Wireless siren
» Register wireless sirens
Enter + 621 + NS + Enter + Activate the siren by pressing the synchronisation
key
NS = siren number from 01 to 16.
» Delete wireless sirens
Enter + 721 + NS + Enter
NS = siren number from 01 to 16.
» Wireless siren partition
Enter + 222 + NS + PP + Enter
NS = siren number from 01 to 16.
PP = partition from 00 to 16 (00 = common address for all zones and 01 to 16
the individual center partitions).
» Enable/disable the siren beep on system activation/deactivation
Enter + 510 + Enter + Key 3 + Enter
» Enable/disable the siren beep per partition
Enter + 224 + GP + Enter
GP = group of partitions, with partitions 01 to 10 in group 0 and partitions 11
to 16 in group 1.
» Changing the siren time
Enter + 41 + TS + Enter
TS = siren time from 01 to 99.
Note: factory default 5 minutes , and if placed 00 on the command will be
beeped error.
» Register range RF amplier (REP 8000 repeater)
Enter + 622 + NA + Enter + Activate the amplier by pressing the synchronisation
key