17
» Features Sound power from 100 dB to 1 meter.
» Communication status check through LED.
» Audible trigger if communication is lost with the alarm center.
» Wireless communication with the alarm center (915 to 928 MHz) via internal
antenna, power 11 dBm.
» DC Power Supply:1 Li-SoCl2 3.6 V / 14 A non-rechargeable battery with wire/
connector - included.
» Communication supervision and encrypted transmission.
» Range: up to 600 m with direct view in open eld.
The following gure shows the illustrative siren image:
XSS 8000 Wireless Siren
XSS 8000 siren has a tamper key against violation, located at the back of the
siren, and if this key is opened/violated, registered sirens will trigger and send the
corresponding event if the
Problems that generate trigger
function is enabled (see
section
Problems that generate trigger
).
Siren can be installed on several surfaces, always placing it in a vertical position
with a height between 1.80 and 2.20 meters from the oor and using double-
sided tape or screws (not included) to x the base and after securing the device,
tting and checking that it has been placed correctly so that there are no falls
and damage. The status of the siren communication with the alarm center will
be represented on it through the indicator LED located on the front, and when
in normal communication the LED will ash green, with partial communication
orange and no communication red (the indicator LED after 15 minutes will enter
hibernation mode for battery saving, not hindering the device communication and
to activate again press the device synchronisation key once).
To Next Page
Loading...
