18
3.6. Wireless magnetic sensor - XAS 8000
Optional dedicated accessory for door and window open checking in a distinctive,
discreet and compact design. With low battery indication and sensor communication
status, supervision, activation and anti-violation system with internal tamper to
compose the 8000 line security system with maximum results.
Features
» Wireless communication with the alarm center (915 to 928 MHz) via internal
antenna, power 11 dBm.
» Communication status check through LED.
» Fastening by screws (not included) or double-sided tape (not included).
» DC Power Supply:1 CR2450 type 3 Vdc battery of long life lithium.
» Communication supervision and encrypted transmission.
» Range: up to 600 m with direct view in open eld.
The following gure shows the illustrative image of the XAS 8000 sensor:
XAS 8000 aperture sensor
XAS 8000 sensor has a tamper key against violation, and if this key is opened/
violated, registered sirens will trigger and send the corresponding event if the
Problems that generate trigger
function is enabled (Problems that generate
trigger). The status of the sensor communication with the alarm center will be
represented on it through the indicator LED located on the front, and when in
normal communication the LED will ash green, with partial communication
orange and no communication red (the indicator LED after 15 minutes will enter
hibernation mode for battery saving, not hindering the device communication and
to activate again press the device synchronisation key once).
To Next Page
Loading...
