26
1. Connector for network cable (Ethernet).
2. CPU card of the AMT 8000 alarm center.
3. Mini-USB type connector for alarm center rmware update.
4. Alarm center CPU card indicator LED.
5. Alarm center board connector for interconnecting the FXO 8000 telephone line
module.
6. Alarm center board connector for interconnecting the XAG 8000 GPRS module.
7. Pin-type connector (2×5-way) for rmware update of the alarm center.
8. Key for wireless device registration.
9. Input connector for telephone line.
10. Output connector for telephones.
11. CPU board for FXO 8000 telephone line module.
12. Flat cable connector for the XAG 8000 module.
13. Connector for SIM 1 card and SIM 2 card.
14. Connector for external antenna of the XAG 8000 GPRS module.
15. CPU card of the XAG 8000 GPRS module.
16. External GSM antenna (included with XAG 8000 module).
17. Connector for at cable for the output of the telephone line signal to the alarm
center board.
18. 3.7 V battery.
19. Flat cable connector for DC output from power supply.
20. Input connector for two-way battery cable.
21. XFT 8000 power supply board.
22. Protection fuses (2 x 250 Vac/400 mA).
23. Connector to connect the ground to the power supply (ground).
24. AC input of the power supply (switched full range - 90 to 265 Vac).
25. Flat cable input of the power supply.
26. Radio connector (future use).
Attention: the AMT 8000 alarm center does not have an auxiliary output to feed
other devices and no connection point must be used on the alarm center cards
(alarm center, GPRS card, telephone line card or source) for this functionality,
because besides damaging the alarm center, it may damage the devices due to the
alarm center operating at different voltages according to the circuit.
To Next Page
Loading...
