70
Delete the passwords using the master password
The master user password - 00 can only be changed and not deleted. User
passwords 01 to 97 can be deleted.
To program this function, type:
+
20 User
+
Enter Enter
01 to 97
+
Password Permissions
Secondary passwords that are created (01 to 96) will be allowed to enable/disable
the entire system and can be enabled to have the following accesss/permissions
according to the needs of each installation.
» Partition: passwords with this permission will only be allowed to enable/disable
the partitions (01 to 16) previously selected via command.
» Only active: the selected passwords can enable the system, but will not be
allowed to disable.
» Bypass: initially, only the master password is allowed to perform temporary zone
cancellation (bypass), the passwords selected for this function will be allowed to
cancel zones at the time of system activation.
» Partial (stay): passwords with this function enabled, may enable the unit leaving
enabled only the environment where it has zones that were previously congured
for
Partial
mode (stay). Remember that this function can be applied to both the
partitioned and the non-partitioned alarm center.
These 4 permissions can be enabled simultaneously for any of the passwords from
01 to 96, for example, user 15's password can have at the same time permission to
only enable partition 01, enable
Partial
mode (stay) and also perform zone override
of partition 01.
The commands to enable/disable the permissions described above are exposed
below:
To Next Page
Loading...
