78
» Exit programming mode with installer password
Installer password (factory standard:
9090
)
» Check the GPRS signal level
Press the
Menu
key, navigate through the arrow keys, access the
GPRS Signal
option and check the signal through the 1 to 10 markings.
» Check connection to IP Receiver service
Press the
Menu
key, navigate through the arrow keys, access the
Connections
option and check if the marking for the
GPRS:
option
IP1
and/or
IP2
is lled.
If so, the unit is connected via GPRS with the IP receiver software through the
chips that have been enabled.
Program SMS
Alarm center can send information messages via SMS to the programmed mobile
phones. The commands to be programmed are as follows:
Note:
after inserting each command and conrming with the
Enter
key, two quick
beeps must be heard, indicating that the programming was accepted, otherwise,
there was some error.
» Entering the programming mode with the installer password
Enter + installer password
(factory default:
9090
)
» Program GPRS channel options to enable chips and SMS sending/receiving
Enter + 832 + Enter
After the command, use the keys on the keyboard to enable
1 (chip 1), 2 (chip
2), 3 (send SMS), 4 (receive SMS)
options and press the
Enter
key to conrm.
» Select SMS events
Enter + 833 + Enter
After the command, use the keys on the keyboard to enable
1, 2, 3, 4
options
and press the
Enter
key to conrm.
» Program phone to SMS
Enter + 84 + M + Phone number with up to 20 digits + Enter
, where M =
memory number ranging from 1 to 5.
The phone number must be a maximum of 20 digits and in format:
0 + operator
code + area code + phone number starting with the digit 9.
To Next Page
Loading...
