Intelbras AMT 8000 - Page 77

77
» Enable the chip to be used
Enter + 832 + Enter
After the command, use the keys on the keyboard to enable options 1 (chip 1),
2 (chip 2).
» Program login
Enter + 822 + O + Enter , where O = 1 or 2 (Operator 1 ou Operator 2)
After the command, type the login (according to the operator used) and then
press the Enter key to conrm.
» Program password
Enter + 823 + O + Enter , where O = 1 or 2 (Operator 1 ou Operator 2)
After the command, type the password (according to the operator used) and
then press the Enter key to conrm.
» Program APN
Enter + 824 + O + Enter , where O = 1 or 2 (Operator 1 ou Operator 2)
After the command, type the APN (according to the operator used) and then
press the Enter key to conrm.
» To program the PIN (Personal Identication Number)
If you wish to use the PIN, execute the command shown in the sequence,
otherwise move to the next command.
If the PIN is incorrect the chip will be locked.
Enter + 825 + O + PIN number with 4 digits + Enter , where O = 1 or 2 (Operator
1 or Operator 2)
» Heartbeat GPRS interval (link test)
Enter + 827 + TTM + Enter , onde TTM = Heartbeat interval time from 000 to
255 minutes (default 005 minutes )
» DNS Servers for GPRS
Enter + 828 + S + Enter , where S = 1 or 2 (Server 1 or Server 2)
After entering the command, enter the DNS server code (according to the server
used) and then press the Enter key to conrm.
» Interval between GPRS connections attempts
Enter + 829 + TG + Enter , where TG = interval time of reconnection attempts
from 00 to 20 (standard 00 minutes )