intelektron BC9000R - Installation Steps; Pre-Installation and Preparation

INSTALLATION INSTRUCTIONS Pg-3
FOR BC9000R AND BC9000RW
No-Tools Face Plate
*Ifyou feel you arc experiencing allY problcms during installation PLEASE
feel free to call our toll free number hetwecn
X:30 AM to 12:00 noon or from
1:00
PM to 4:30 PM Pacific Standard Tilll\": Monday through Friday, for
immediate service.
1-(800)-828-9887
OR
(415) 732-()790
lampholder
Adjustment" ~
/.Lam
P
hOlder Fiber washers
~ MountIng Screws
/\ C» c:» ~ T T
/i) 0 Wire Nuts
l~ a I!\IU
JunctIon Box Decorative Lampholder Covers
Seal1ng Gasket
MotIon Detector Head
1) CHECK LOCAL ELECTRICAL CODES BEFORE INSTAL-
LATION.
2) IMPORTANT - TURN THE POWER OFF AT THE MAIN
FUSE BOX
IN YOUR HOME BEFORE YOU START (FIG.1).
3) CAREFULLY REMOVE THE EXISTING FIXTURE.
4) DETERMINE WHICH PLATE
OFF ON
MOUNTING HOLES ARE
REQUIRED. IF THE
I-
COVERED HOLES ARE
REQUIRED, PLACE THE
MAIN
FACE PLATE ON A FIRM
SURFACE AND TAP THE
FIG. 1
KNOCK OUT PLUGS OUT
WITH A HAMMER
AND SCREWDRIVER. SEAL THE
UNUSED MOUNTING HOLES WITH SILICONE SEALER.
5) CAREFULLY THREAD THE MOTION DETECTOR WIRES
THROUGH THE LOWER FACE PLATE HOLE AND
SCREW
IN THE MOTION DETECTOR.
...