150
Firmware upgrade
status page
5. It'll display information about the upgrade process status on full screen.
Upgrade procedures:
1. Select the upgrade package le. In Auto Upgrade mode, check new rmware le
automatically by clicking Check button.
2. Click on “Start Upload” button to transfer the Firmware package le (“*.fwp”) to E2S
(Ethernet to serial) module. In Auto Upgrade mode, click "Upgrade" button once new
rmware le is detected.
3. After the package le is transferred, it’ll show “upgrade from vx.xx Version to vx.xx
Version”. Enable the check box to select the rmware le that you wish to upgrade.
To select all rmware les, click Select All Firmwares.
4. Click on “Start Upgrade” button.
To Next Page
Loading...