Intellitec Battery Disconnect BD0 - Indicator Off, Relay On (BD2;BD3 Chassis); No Voltmeter Reading (Coach) (BD3)

No voltmeter reading on
battery disconnect panel
display panel. BD3 MODEL
ONLY
INTELLITEC
PDX RV LLC
BATTERY DISCOECT
Chassis
indicator light
is off
although relay is on
(latched). BD2 & BD3
MODELS ONLY
Trouble Shooting
Problem
Possible
Cause / Solution
Check fuses on
chassis
relay
. If not blown
go to step
68, if blown replace with size fuse and retest. If fuse /
fuses re-blow go to step 9.
STEP 67
Remove the battery disconnect panel from cabinet
/ console and with a multi-meter set on DC
voltage, measure between the yellow wire at pin #
11 and the black wire on pin # 6. The voltage
should read whatever DC voltage as the batteries
read (typically around 12 volts). If it reads 0 VDC
then inspect the harness for damage, or replace
harness, refer to PARTS LINK #1 (page 7). If the
voltage reading is the same as the nominal battery
reading then replace battery disconnect panel, refer
to PARTS LINK #2 (page 8)
STEP 68
Trouble Shooting
Problem
Possible
Cause / Solution
Check fuse
on
house
relay
that attaches to the green
wire. If not blown go to step 69, if blown replace
with size fuse and retest. If fuse / fuses re-blow go to
step 9.
STEP 68
Remove the battery disconnect panel from cabinet
/ console and with a multi-meter set on DC
voltage, measure between the green wire at pin # 5
and the black wire on pin # 6. The voltage should
read whatever DC voltage as the batteries read
(typically around 12 volts). If it reads 0 VDC then
inspect the harness for damage, or replace harness,
refer to PARTS LINK #1 (page 7). If the voltage
reading is the same as the nominal battery reading
then replace battery disconnect panel, refer to
PARTS LINK #2 (page 8)
STEP 69
20