Intellitec Battery Disconnect BD0 - No Voltmeter Reading (Chassis) (BD3)

INTELLITEC PDX RV LLC
BATTERY DISCOECT
No voltmeter reading on
battery disconnect panel
display panel (Read Volts
Coach). BD3 MODEL ONLY
Trouble Shooting
Problem
Possible
Cause / Solution
Check fuse
on
house
relay
that attaches to the green
wire. If not blown go to step 70, if blown replace
with size fuse and retest. If fuse / fuses re-blow go to
step 9.
STEP 69
Remove the battery disconnect panel from cabinet
/ console and with a multi-meter set on DC
voltage, measure between the green wire at pin #
10 and the black wire on pin # 12. The voltage
should read whatever DC voltage as the batteries
read (typically around 12 volts). If it reads 0 VDC
then inspect the harness for damage, or replace
harness, refer to PARTS LINK #1 (page 7). If the
voltage reading is the same as the nominal battery
reading then replace battery disconnect panel, refer
to PARTS LINK #2 (page 8)
STEP 70
Trouble Shooting
Problem
No voltmeter reading on
battery disconnect panel
display panel (Read Volts
Chassis). BD3 MODEL ONLY
Possible
Cause / Solution
Check fuse
on
chassis
relay
that attaches to the
yellow wire. If not blown go to step 70, if blown
replace with size fuse and retest. If fuse / fuses re-
blow go to step 9.
STEP
71
STEP 72
Remove the battery disconnect panel from cabinet
/ console and with a multi-meter set on DC
voltage, measure between the yellow wire at pin #
11 and the black wire on pin # 12. The voltage
should read whatever DC voltage as the batteries
read (typically around 12 volts). If it reads 0 VDC
then inspect the harness for damage, or replace
harness, refer to PARTS LINK #1 (page 7). If the
voltage reading is the same as the nominal battery
reading then replace battery disconnect panel, refer
to PARTS LINK #2 (page 8)
21