Intenso BA2 - Device Overview; LED Status Display; Operation; Start-Up; Charging Compabible Devices

USE
Device overview
1 - USB-C In
2 - Status LED
Operaon
LED status display
The current operang status of the device is
indicated by the status LED. If you connect the
device to a connected power supply unit, the LED
ashes green once and blue once as conrma-
on and then remains o. If a charging process
is started, the LED lights up blue connuously.
When the terminal is fully charged, the LED usually changes from blue to green (depending on the char-
ging device). If the LED ashes blue quickly, there is an error – for example, the device is not posioned
correctly, it has become too hot, there is a foreign object between the devices or an incompable power
supply unit is being used.
Start-up / charging compable devices
Step 1: Preparaon
Connect the supplied USB-C to USB-C cable to the USB-C port (IN) of the inducve charging staon and
connect the other end of the USB cable to the power supply unit. Next, connect the power supply unit to a
power socket (follow the safety instrucons).
Step 2: Start charging
Posion your Qi-compable device in the centre of the inducve charging staon. The charging process
starts automacally, and the status LED lights up blue connuously.
If this is not the case, please check
a. whether your device is Qi-compable
b. whether there is a foreign object between the devices or you are using an unsuitable case.
c. whether you have chosen the enclosed power adapter or a dierent but compable one. If this is
not the case, replace it accordingly. If this is the case, please disconnect it from the power supply for
a few seconds and reconnect it to start the charging process.
d. whether the cable ends and the power supply unit are correctly connected.
e. where the correct wireless charging posion is on your device. You may need to reposion it.
Please note that the ambient temperature and the charging electronics of the device to be charged have
an eect on the charging behaviour over which the inducve charging staon itself has no inuence. For
example, the charging speed may be reduced at increased temperatures or when charging levels have
already been reached.
Step 3: End charging process
To end the charging process, simply remove your device from the inducve charging staon.
EN - Page 4 of 5