8. Using PC or MAC
8.1. Liaise a wireless LAN connection with the PC
Switch-on “Memory 2 Move” by pressing the power button at the front panel.
Wait for few minutes until the Wireless LED stops blinking. Enable the Wi-Fi feature on your PC and
open the Wireless Network Connection. Select the “Memory 2 Move” wireless connection (default
wireless SSID: Memory2Move-XXXX and password: intenso1).
Note: For your own safety, please change your password after successful connection.
Once you have successfully connected to “Memory 2 Move”, you may now run the “WiFi-Finder” to
search for your device and complete the configuration process.
With our included “Wi-Fi Finder” you don´t need to install any software, simply double-click on
below icon to start it. The Wi-Fi Finder allows you to easily search your “Memory 2 Move”.
8.1.1. PC WiFi Finder
Double-click the “Wi-Fi Finder” icon to start the software. This utility will search for the M2M in your
network as mentioned on below screenshot
If you do not find the Memory 2 Move on the list of devices connected in your network, click on the
“Refresh” button to update the device list.
Select the Memory 2 Move on the list, and then click on the “Log In” button to enter the web
interface.
To Next Page
Loading...
