Inter-m H-3200 - Specifications; Electrical Specifications; General Specifications

14
H-3200/4200
PROFESSIONAL POWER AMPLIFIER
Specifications
Specifications
- ELECTRICAL
- GENERAL
H-3200 H-4200
Power Source 100–120VAC or 220–240VAC; 50/60Hz
(Supplied AC mains transformer depends on country requirements)
Weight 32kg/70.5lb 35kg/77.2lb
Dimensions 482(W)×132(H)×475(D)mm/19(W)×5.2(H)×18.7(D)in
Power Output Level
STEREO 1kHz both channels driven
R
L =8Ω @ 0.1% THD 800W 1000W
R
L =4Ω @ 0.1% THD 1200W 1600W
R
L =2Ω @ 0.1% THD (1ch driven) 1600W 2100W
BRIDGED R
L =8Ω 1kHz @ 0.1% THD 2400W 3000W
R
L =4Ω 1kHz @ 0.5% THD 3200W 4200W
Frequency Response R L =8Ω, P=1W 20Hz~20kHz: ±0/1dB, 5Hz~70kHz: -3dB
Total Harmonic Distortion(THD+N)
f=20Hz~20kHz, 1/10 Power
STEREO R
L =8Ω &4Ω ≤0.03%
BRIDGED R
L =8Ω ≤0.03%
Channel Separation Half Power R L =8Ω,
≥80dB
f=1kHz, ATT. max. Input 600Ω shunt
Residual Noise (DIN Audio Filter) ≤-85dB: ATT min.
Signal-to-Noise Ratio (DIN Audio Filter)
≥107dB
Input 600Ω Shunt
Standard Input Sensitivity
1V 1V
(Rated Power into 4Ω 1kHz)
Damping Factor R
L =8Ω, f=1kHz ≥450
Voltage Gain (ATT max.) 4Ω 1kHz 69dB 78dB
Output Circuitry H-Class H-Class
Input Impedance (ATT max.) ≥20kΩ(Balanced/Unbalanced)
Indicators Active, Clip/Limiter, Signal, Protection
Protection Power SW ON/OFF muting, Full short circuit
Thermal, RF, Ultrasonic
Fan Circuit Low-Speed-Variable-Hi-Speed
Connectors Input: balanced combination connector (XLR type+1/4” TRS)
Output 5-Way binding posts×2, Speakon
TM
Terminal×2