MS-50BT/MS-50WT Heavy-Duty Monitor Speaker
Maintaining Proper Polarity
It is very important to wire your speakers consistently in order to maintain proper
polarity. All quality cables are manufactured with clear markings to identify the
different conductors – normally by color-coding, printed markings, or textured ribbing
on the cable’s jacket material. Failing to do so will cause your speakers to operate
out of phase, resulting in significantly reduced low-frequency output from your
system.
Choosing the Correct Amplification
When selecting an amplifier for use with your speaker system, it is important to choose an
amplifier that has sufficient power output.
Choosing an amplifier that does not have adequate rated power may result in pushing
the amp beyond its limits, producing distortion or “clipping” of the signal. This can irritate
the listener and may cause damage to the speaker.
Choosing an amplifier that is over-powered can result in over-driving the speaker system.
Using Multiple Loudspeakers
It is important to consider the overall speaker load (impedance) when connecting
distributed speaker systems to an amplifier. Some distributed loudspeakers are marked in
load impedance; others show the wattage taps. Whatever the case, it is easy to
compute the total impedance (or wattage load) that is possible for a given amplifier.
Alternatively, the MS-50BT/MS-50WT can operate in a distributed system at 100V.
8
To Next Page
Loading...
Need help?
General
