Tuner Section
PUBLIC ADDRESS AMPLIFIER/RECEIVER
5
PA-1000B/1000BR
Tuner Section (PA-1000BR ONLY)
1. TUNING FREQUENCY DISPLAY
Displays the current frequency of the tuner.
2. TUNING LED (PA-1000BR ONLY)
This indicator lights when the digital tuner has locked onto a signal.
3. AM/FM BAND SELECTOR AND MEMORY SWITCHES (PA-1000BR ONLY)
This AM/FM Band Selector Switch is used to select the AM or FM frequency band. Pressing the Memory
Switch followed by one of the six Address Select switches will enter the currently selected frequency into the
designated memory address.
4. ADDRESS SELECT SWITCHES (PA-1000BR ONLY)
These switches select between the six memory address banks used to store radio frequency presets. Each bank
can hold up to five individual presets – three FM (F1, F2, F3) and two AM (A1, A2), for a total of 30 presets.
5. UP AND DOWN SWITCHES (PA-1000BR ONLY)
Pressing these switches will move the tuner to the next active frequency. Holding the switch down for more
than one-half second will activate “Auto-Scan” mode, causing the tuner to scan, pausing for a few seconds at
each active frequency. Pressing the Up or Down switch again will de-activate “Auto-Scan” mode.
6. TUNER LEVEL (PA-1000BR ONLY)
This knob controls the tuner output level. Rotating the knob fully counter-clockwise switches the tuner section off.
PA-1000B_BR_E_PA-1000B_BR_E 10. 10. 28. 오전 9:42 페이지 8
To Next Page
Loading...
Need help?
General
