Inter-m PD-9359 User Manual

5
PD-9359
POWER DISTRIBUTOR
Rear PanelRear Panel
1. AC OUTLET (SWITCHED)
AC power is also supplied by this outlets when operating of power switch or remote control.
2. DC OUT TERMINAL
This terminal is supplied DC power of rack system when operating of power switch or remote control.
*NOTE: Please consider current not to exceed rated maximum current 5 amps.
3. BATTERY OUT TERMINAL (for AMP)
The output of battery power is supplied when unexpected power failure, we recommend you this
terminal is for Amplifier or high current equipment.
4. CONTROL TERMINALS
These terminals are for operating of remote control and supply of DC power. If you want to connect
the any equipment operated by DC 24V, please use these. Also, if you can use the H&C terminal this
system will be operated without control of power switch.
5. TERMINAL FOR EMERGENCY EQUIPMENT
DC 24V for emergency equipment turn on always, and it is independent with power switch or remote
control.
6. AC OUTLET (UNSWITCHED)
AC power is always supplied by this outlet. If any equipment must be always turned ON, please use
this outlet.
7. BATTERY INPUT TERMINAL
This terminal is supplied DC power from the battery charger when unexpected AC power failure.
SWITCHED
DC OUT 24V
5A MAX
SWED 1 (2000W)
SWED 2 (2000W)
SWED 3 (2000W)
( )
( )
SWITCHED DC OUT 24V
UNSWITCHED
DC OUTPUT 24V
REMOTE
C-SW-H
BATTERY
INPUT
( )
( )
UNSWED (700W)
(RACK ONLY)
(AMP ONLY)
~AC INPUT
120V/60Hz,217VA
HOT
6
7 89
( )
EMERGENCY
AC FUSE
T2AL/250V
DC FUSE
5A/250V
GND
www.inter-m.com
542 31

Inter-m PD-9359 Specifications

General

Brand	Inter-m
Model	PD-9359
Category	Power distribution unit
Language	English