8 / 9© INTEREL 2021 - rev07
• Always power o the system before cleaning.
• Always use an anti-static wristband or other professional grounding devices.
• Never spray cleaning uids directly onto components. Always spray the cleaner onto a soft cloth then wipe.
• Do not allow any cleaner to run or drip near circuit boards, or near seams on device casings.
• Never allow circuits or electronics to become damp or wet.
• Some cleaning solvents can damage components. In most cases, water will work just as well.
• Do not attempt to clean any electronic components such as circuit boards or wire connection terminals.
• Hands shall not be wet when plugging and unplugging exible cords and connected equipment.
• Avoid the use of alkaline solution to clean the glass. Do not spray solvent directly onto glass face.
• Always use a soft cloth to wipe the glass when using solvent cleaner.
Cleaning procedures
Cleaning control panels shall start by wiping o any dust or debris with a clean and
dry microber cloth. Avoid direct spraying of cleaning uids onto the control panels or
electrical wiring.
To Next Page