Chapter 5: Menu reference
268 Advisor Advanced ATSx500A(-IP) Installation and Programming Manual
Note: Particular options in this menu differ for specific transmission paths. For
specific options, see:
• “PSTN specific options” on page 269
• “ISDN specific options” on page 270
• “IP specific options” on page 270
• “GSM/SMS/GPRS specific options” on page 273
Common options
9.3.n.1 Path name
Use the path name screen to enter or change the transmission path name. The
name can consist of up to 16 characters.
9.3.n.2 Line fault
If the Line fault option is set to Always, the line is tested for line faults. If a line
fault is present a fault is generated in the system.
If Line fault is set to “If used”, the line is being tested only if this path is used for
any central station communication, and the account number for this station is set.
9.3.n.4 Expander menu
Particular diallers have their internal menus. Enter Expander menu to set internal
dialler options.
The menu content depends on the equipment.
9.3.n.8 Ring setup
1>Ring count
2 Omit 1st call
The menu contains ringing configuration options.
Note: This option is not available for IP connection.
9.3.n.8.1 Ring count
The Ring count screen lets you enter the number of rings before answering an
incoming call. The allowed range is 1 to 15. Higher value is equal to infinity, so
incoming calls are not answered at all.
To Next Page
Loading...
Need help?
General
