1 Position the mounting brackets over the screw holes then using the screws
(included) mount the brackets to the multidock. The mounting holes are 15-3/4
inches (40.01 cm) apart.
2 On framed walls, it is preferable to drive lag screws directly into studs whenever
possible. If this is not possible, it may be necessary to install scab studs or
plywood (5/8 inch thickness or greater) reinforcement.
3 Position mounting brackets at a suitable height and use 1/4 inch or larger
hardware *(lag screws or concrete fasteners) to secure mounting brackets to the
wall. Use two fasteners in each bracket.
4 When installing several multidocks across a wall, be sure to allow clearance
between them for the power cables.
1 Position the mounting brackets over the screw holes then using the screws
(included) mount the brackets to the multidock. The mounting holes are 15-3/4
inches (40.01 cm) apart.
2 On framed walls, it is preferable to drive lag screws directly into studs whenever
possible. If this is not possible, it may be necessary to install scab studs or
plywood (5/8 inch thickness or greater) reinforcement.
3 Position mounting brackets at a suitable height and use 1/4 inch or larger
hardware *(lag screws or concrete fasteners) to secure mounting brackets to the
wall. Use two fasteners in each bracket.
4 When installing several multidocks across a wall, be sure to allow clearance
between them for the power cables.
1 Position the mounting brackets over the screw holes then using the screws
(included) mount the brackets to the multidock. The mounting holes are 15-3/4
inches (40.01 cm) apart.
2 On framed walls, it is preferable to drive lag screws directly into studs whenever
possible. If this is not possible, it may be necessary to install scab studs or
plywood (5/8 inch thickness or greater) reinforcement.
3 Position mounting brackets at a suitable height and use 1/4 inch or larger
hardware *(lag screws or concrete fasteners) to secure mounting brackets to the
wall. Use two fasteners in each bracket.
4 When installing several multidocks across a wall, be sure to allow clearance
between them for the power cables.
Instructions
Corporate Headquarters
6001 36th Avenue West
Everett, Washington 98203 U.S.A.
tel 425.348.2600
www.intermec.com
© 2005 Intermec Technologies
Corporation. All rights reserved.
CK60 Multidock Mounting Brackets Installation Instructions
*931-001-001*
P/N 931-001-001
Instructions
Corporate Headquarters
6001 36th Avenue West
Everett, Washington 98203 U.S.A.
tel 425.348.2600
www.intermec.com
© 2005 Intermec Technologies
Corporation. All rights reserved.
CK60 Multidock Mounting Brackets Installation Instructions
*931-001-001*
P/N 931-001-001
Instructions
Corporate Headquarters
6001 36th Avenue West
Everett, Washington 98203 U.S.A.
tel 425.348.2600
www.intermec.com
© 2005 Intermec Technologies
Corporation. All rights reserved.
CK60 Multidock Mounting Brackets Installation Instructions
Need help?
General
