Chapter 6 — Configure the Computer
70 Series Mobile Computer User Manual 95
8 For Pre-Shared Key, enter the pre-shared key or passphrase.
The pre-shared key must be a value of 32 hex pairs preceded by 0x
for a total of 66 characters. The value must match the key value on
the access point. The passphrase must be from 8 to 63 characters.
After you enter a passphrase, the 70 Series internally converts it to
a pre-shared key. This value must match the passphrase on the
authenticator.
9 Save your settings.
Configure 802.1x Security with Funk Security
Use the following procedure to configure 802.1x-WEP security with
Funk security. Intermec recommends that you use WPA2-802.1x
instead of 802.1x-WEP if possible.
1 Make sure the communications and radio parameters on your
computer are configured.
2 Make sure Funk is selected as your security choice.
3 Start Intermec Settings.
4 Select Communications > 802.11 Radio > Funk Security.
5 Select the profile you want to configure.
6 For Association, select Open.
7 For Encryption, select WEP.
8 For 8021x, select TTLS, PEAP, or TLS.
9 If you selected TTLS or PEAP:
a Enter a User Name.
b For Prompt for Credentials, select Enter credentials now.
c Enter a User Password.
d For Validate Server Certificate, select Yes.
To Next Page
Loading...
