Intermec CK71

Chapter 6 — Configure the Computer
96 70 Series Mobile Computer User Manual
10 If you select TLS:
a Load a user and root certificate on your computer. For help, see
“Load a Certificate” on page 102.
b For Validate Server Certificate, select Yes.
c Enter a User Name and Subject Name.
11 Save your settings.
Configure LEAP Security with Funk
After you configure the communications and radio parameters on
your mobile computer and select Funk as your security choice, you can
configure LEAP.
1 Start Intermec Settings.
2 Select Communications > 802.11 Radio > Funk.
3 Select the profile you want to configure.
4 For 8021x, select LEAP.
5 For Association, select Open, WPA, WPA2, or Network EAP.
Encryption automatically defaults to TKIP if you selected WPA,
AES if you selected WPA2, and WEP if you selected Open or
Network EAP.
6 For Prompt for Credentials, select Enter credentials now.
7 Enter a User Name and User Password.
8 Save your settings.
Configure Static WEP Security with Funk Security
Use the following procedure to configure static WEP security with
Funk. Intermec recommends that you use WPA2-PSK instead of WEP
if possible.
1 Make sure the communications and radio parameters on your
computer are configured.
2 Make sure Funk is selected as your security choice.
3 Start Intermec Settings.
4 Select Communications > 802.11 Radio > Funk Security.