1 CV60 SDRAM Upgrade Instructions
Packing List
Check to make sure the items shown on the next page were
included in your shipment. If any item appears to be missing or
damaged, contact your Intermec representative.
You must follow standard ESD guidelines to avoid
damaging the equipment you are servicing.
The memory module is a sensitive piece of equipment, so be
careful when handling the module - especially for ESD (Electro
-
static Discharge), make sure that you are properly grounded.
Note: Use of unapproved SDRAM modules may void
your warranty.
Note: It is recommended that if you are using the Win-
dows XP Embedded operating system, that you have an
IDE drive, either solid state or rotating media, with at
least 1GB of capacity. Some older systems do not have
sufficient swap space to support memory upgrades.
Introduction
These instructions outline the SDRAM upgrade procedures for
the CV60 Vehicle Mount Computer.
Make sure that the power is fully off and the CV60 Computer is
unplugged from the power source.
SDRAM Connector Slot
To Next Page
Loading...
Need help?
General
