Need help?Do you have a question about the Intermec CV60 and is the answer not in the manual?
Provides a summary of safety information, warnings, and cautions for handling Intermec equipment and preventing injury.
Identifies the location and function of all ports and connectors on the bottom panel of the CV60.
Explains how to access the hard drive and SODIMM memory slot for upgrades or replacement.
Details the AC power supply unit used for desktop mounting and its operational requirements.
Describes the DC power supply kits for vehicle mounting and their supported input voltage ranges.
Provides guidance on routine maintenance, including cleaning procedures and daily checks for the CV60.
Lists the processor type, memory capacity, storage options, and display specifications of the CV60.
Ensures proper setup before powering up the computer, checking connections and power sources.
Describes the steps involved in starting up the computer after connections are made and power is applied.
Step-by-step instructions for installing the media drive into the drive bracket.
Instructions for installing a solid state drive, including jumper settings and ribbon cable connections.
Details on upgrading the CV60's base memory using the SODIMM slot.
Instructions for installing and removing PC Cards from the PCMCIA slot.
Step-by-step guide for inserting a PC Card into the computer's slot.
Instructions for setting up and associating a cordless scanner with the CV60.
Information on starting up the CV60, including connecting accessories and installing operating system software.
Instructions for performing warm and cold restarts on the CV60 to resolve system issues.
Guidance on configuring the CV60 for data collection tasks using Intermec settings.
Details on using the Intermec Settings utility to configure device parameters and options.
Configuration options for the primary master drive, including type, 32-bit I/O, and transfer mode.
Settings for the secondary master drive, covering auto-detection, CD-ROM, IDE removable, and ATAPI removable options.
Configure COM port for UPS service, polling frequency, and automatic shutdown settings.
Reboot the system with a default system registry.
Configuration of Dynamic Host Configuration Protocol (DHCP) for automatic IP addressing.
Configuration of TCP/IP settings for network connectivity on Windows CE and Windows XP.
Information on the Intermec Tethered Scanner feature and its configuration.
Guide to configuring tethered scanners via the Intermec Settings on the CV60.
Detailed pinout description for the COM1 and COM2 serial ports.
Pinout for the 6-pin mini-DIN PS/2 connector used for external keyboards.
Pinout for the RJ-45 8-pin modular connector used for Ethernet local area network connections.
Details the pinout for the external USB 1.1 ports used for connecting peripherals.
Illustrates the microphone and headphone jacks on the CV60.
Provides the pinout configuration for the CV60's power connector.
To Next Page
General
