27CV60 Vehicle-Mount Computer User's Manual
PhoenixBIOS Setup Utility
3
A PS/2Ćcompatible keyboard is required to configure the PhoenixBIOS
Setup Utility (PSU). Turn off the CV60 Vehicle-Mount Computer before
attaching the keyboard, if one is not attached already.
Reboot the CV60. Be ready to press the [F2] keys when the following
prompt appears on the bottom, left side of the Intermec screen:
Press F2 for System Utilities
When you see this prompt, you have approximately eight seconds to press
the [F2] key to enter the PSU, otherwise the computer proceeds to boot
up.
Note: Any changes made to the PSU are not effective until they are saved
and the CV60 is rebooted. Select Exit > Exit Saving Changes to save the
changes.
Press <Esc> to exit any window without changes.
To Next Page
Loading...
