Introduction
—Chapter 1
7CV60 Vehicle-Mount Computer User’s Manual
DC Power Input
This is a 5-pin cir cular power connector with a locking collar.
A regulated +12 volt power supply/converter is required.
PS/2 Keyboard
This is a standard keyboard connector for use with PS/2-type keyboards.
On/Off Switch
This switch is located on the bottom of the device next to the DC power
input connector.
Note: ALWAYS perform a proper system (or Windows) shut-down before
shutting the computer OFF.
COM1, COM2 (Serial Ports)
Each port has its own address and a 9-pin male connector to attach
RS-232 serial devices. COM ports can provide 5 volts dc to support a de-
coding type tethered scanner.
Note: Picolink uses the COM2 serial port, so you have COM1 left for
scanner or serial connection u se. CV60 computers with the Picolink radio
option installed will have a cover plate over the COM2 serial port.
Headphone
This 3.5 mm connector accepts an external headphone.
Network Connection (NET)
The CV60 Vehicle-Mount Computer has Ethernet (10BASE-T, RJ-45
jack) on board.
C aution: The Lithium-ion (Li-Ion) backup battery is not
user-replaceable. Refer to the “Before You Be gin” section of this user
guide for information on where to send your CV60 Vehicle-Mount
Computer for service and warranty repairs.
To Next Page
Loading...
