60
4. Delete programmed blind
1. Select the ‘Menu’ function
©£©©
2.
press and hold, scanning of blind is starting
ªªªª
3.
When blind is located, the 1
st
LED flashes
©£££
.
When no blind has been located, the program returns to
1. Function Selection Menu
£©©©
©£££
4.
press briefly = enable to click through all located blinds
and select the required one
Blinds are sorted according to their signal strength:
©£££
= blind 1
£££©
= blind 4
£©££
= blind 2
©££©
= blind 5
££©£
= blind 3
£©£©
= blind 6 …
Check for activated blind with
or !
©£££
5.
press and hold = confirm selected blind
©£££
6.
press briefly = select blind which is to be deleted
a)
£©©£
= Delete blind on radio transmittor which
was used to carry out action
b)
©££©
= Delete blind on ALL radio transmittors
which were programmed for this blind
£©©£
©££©
7.
press and hold = Deleting process is started
ªªªª
8. Possible feed back:
©©©©
= Ok
LED flashes
ª£££
/
£££ª
(from 1 to 4) =
No communication/error, repeat process
©©©©
9.
press briefly = confirm feed back.
This brings you back to 1. Function Selection menu
©£©©
10.
Further possibilities:
1) press and hold = repeat process
2)
press briefly = to select an option from the ‘Menu’
3)
press and hold or no operation for 25 sec. =
finish installation mode
Press briefly = return to point 1.
14_107_BHB_West.indd 60 02.06.14 13:00
To Next Page
Loading...