Machines manufactured by Hydralok, Bristol, UK
Machine enquiries, sales, after sales service :
Interpump Hydraulics (UK) Ltd t/a IMM Hydraulics (UK) : Kidderminster
Tel : (0)121 550 1115 / sales@immhydraulics.co.uk
Remove the hose and measure the ferrule. Adjust swage size if necessary to
compensate for any discrepancies until correct swage size is achieved. Please see
note on the following page.
Important Note On Swage Dimensions:
The dimensions shown on the display are only an indication of the position of the
machine components and must not be taken at face value. Due to several factors
including fitting design and material, hose characteristics, elastic memory in the
fitting and machine tolerances, the display diameter readout may differ from the
actual ferrule dimension. To overcome discrepancies, adjust the swage size
accordingly (larger or smaller) or use the offset to compensate until the correct
swage size is achieved.
NOTE! Always measure the ferrule after swaging to ensure that it is within the
tolerances given by the hose and fitting manufacturer.
To Next Page
Loading...
