4
MESSAGE WAITING LIGHT - refer to Fig. 1
Enables the user to select a message waiting feature compatible with most
80VDC PABX systems on the Australian market (including : NEC, FUJITSU,
ALCATEL and NORTEL).
To select this feature -
1) Disconnect telephone from line cord.
2) Release the index card and plastic cover from the cradle area on the
base unit of the telephone to expose the message waiting selection
switch.
3) Select the message waiting (mw) setting.
4) Replace the index card and plastic cover then reconnect the line
cord.
3. OPERATION
OUTGOING CALL
- Lift the handset,
- Listen for the dial tone,
- If your line has been programmed to act as a hotline, the connection will be
established by the system.
HEARING-AID COMPATIBILITY
Provided as a standard feature for users with a "T switch" type hearing-aid.
RINGER INDICATOR / MESSAGE-WAITING LIGHT (OPTIONAL)
Flashes when the telephone rings with an incoming call. It may also function as
a 'message-waiting' indicator lamp (optional - see Installation section).
To Next Page
Loading...
