8
Apply power to the main unit using the universal IEC power connector input on the back
of the main unit. The touch screen will display a Splash Screen Page with the option to
continue or to be directed to the Help pages.
The remote displays will remain off until either one of the profiles has been started or
the clock mode has been selected.
Programming a Timer Profile
(Information about programming can also be found under the Help pages on the device
itself)
Please make sure you are using the latest firmware version.
For the latest firmware update go to our website www.interspaceind.com.
Setting Count Down
To set count down time use the up and down arrows buttons. Use these buttons to set
the total Green time and for setting Amber and Red Times. Push the Go button and the
time will start counting down. Pushing the same button will pause the timer.
The Off button will turn off the display but the selected profile will continue to run.
Selecting one of the three traffic lights buttons will force the display to this colour and
override the present colour. Select the same traffic light button again to turn off, the
display will then return to the original colour.
Editing running time
Use the Update button and the Green time to cut or extend the display time while run-
ning. For example, to cut the display time by 2 minutes reduce the Green time by 2
minutes then push Update. There is no Update function on the Count Up screen.
Min/Sec button– The system powers up in minutes mode (Min) where just the minutes
can be changed. To change to seconds select the Min button to show Sec and set the
seconds for the Green, Amber and Red times.
The Zero button causes the Green, Amber and Red times to be set to zero. Use this in
conjunction with the Update button to end a Count Down.
To Next Page
Loading...