Intex 28426 - Random Display or 888 Troubleshooting

Page 29
Random Display or 888
If the display is showing random numbers or all the LEDs are lit up, it is possible that there is a connection
problem.
In addition, disconnect and reconnect the cable for the Control Panel.
If reconnecting the Control Panel doesn’t work, try replacing the Control Panel with a new one.
If the above steps do not solve the issue, proceed with replacing the PCB. Refer to the section replacing
the PCB for more details.
No
END
Random Display/ Code 888
Yes
1. Replace Control Panel
2. Replace PCB
Go Back to Next Step
Random Code?