EasyManuals Logo

Intex 52" User Manual

Intex 52"
9 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
(92IO) 52" 2-SECTIONS POOL LADDER ENGLISH 7.5” X 10.3” PANTONE 295U 05/28/2012
92A
SAVE THESE INSTRUCTIONS
Page 8
English
SETUP INSTRUCTIONS
LADDER SETUP (continued)
5. U-SHAPED TOP RAIL
INSTALLATION (refer to figure 4):
Install the U-shaped top rails (1) onto
the legs above the top platform (2)
and fasten them with the shorter
fasteners/screws (3) – see figure 4.
6. INSTALLATON OF THE REMAINING
LADDER SIDE (refer to figure 5):
With all the top rail and top platform
holes in alignment, slide the remaining
ladder side from the underside into its
proper position. Make sure the “A” leg
slides into hole “A” of the top platform
and the “B” leg slides into hole “B” of
the corresponding top platform.
Fasten all parts using the appropriate
fasteners/screws (4) and (3), as
described earlier.
7. BEFORE USE OF LADDER:
With all parts now in place, verify that
all fasteners/screws are fully tightened
and apply downward pressure to each
step to be sure they are fully anchored
in place. If your ladder came with a
ladder barrier, proceed to instructions
for ladder barrier installation,
otherwise proceed to placing the
ladder over the side wall of your pool,
with one side of the ladder located
inside the pool and the other side
outside of the pool - see figure 6.
Estimated assembly time 45 minutes.
(Note the assembly time is only
approximate and individual assembly
experience may vary.)
4
5
6
WARNING
• Locateladderonalevel,solidbaseandmakesuretheladderis
stable and safe to climb.
• Removeandsecureladderawayfromthepoolwhenthepoolis
not in use to prevent unauthorized, unintentional or unsupervised
pool entry.
• Checkallnutsandboltsregularlyandbeforeeachusetoensure
the ladder is sturdy. See maintenance instructions.
8. MAINTENANCE:
Regularly check all nuts, bolts, step mounting fixtures and step mounting
pins to ensure all parts are secured properly and the ladder is sturdy.
Bring the ladder indoors and store in a safe and dry area, preferably
between 32 degrees Fahrenheit (0 degrees Celsius) and 104 degrees
Fahrenheit (40 degrees Celsius).
3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intex 52" and is the answer not in the manual?

Intex 52" Specifications

General IconGeneral
BrandIntex
Model52"
CategoryLadders
LanguageEnglish

Related product manuals