EasyManuals Logo

Intex ECO7111 User Manual

Intex ECO7111
29 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
SAVE THESE INSTRUCTIONS
Page 2
(249PO) MODEL ECO7111 Cartridge Filter Pump & Saltwater System with E.C.O. ENGLISH 7.5” X 10.3” PANTONE 295U 04/06/2017
English
249
PO
S AVE THESE INSTRUCTIONS
English
Page 27
TROUBLESHOOTING GUIDE (continued)
1
. Circulation line is blocked.
2
. Incorrect inlet and outlet hose direction.
3
. Scale on the flow sensor.
4
. Flow sensor cord is loose.
5
. Inner timer confliction between filter
pump and saltwater system.
6
. Flow sensor failure.
1
. Dirt or scale on titanium plates.
2
. Low salt level / No salt.
3
. Electrolytic cell cord is loose.
4
. Possible electrolytic cell failure.
1
. High salt level.
1
. Display and all lights are off - the
system does not power up.
If your unit has plunger valves, ensure that
they are open.
Clear your filter cartridge and cell from debris
and dirt. See “Maintenance”.
Release all trapped air in the circulation line.
See the filter pump manual.
Check the direction of the inlet and the outlet
hose. Reverse the hoses if necessary. See
“Set Up Instructions”.
Clean the flow sensor, paying special attention
to the hinge. See “Maintenance”.
Plug the flow sensor firmly into the flow sensor
receptacle.
Reset both timers on the filter pump and
saltwater system. See “Boost Cycle”.
Contact Intex Service Center.
Remove the electrolytic cell for inspection.
Clean it if necessary. See “Maintenance”.
Add salt. See “Salt & Pool Water Volumes”.
Ensure that the cell cord is plugged firmly into
the cell housing receptacle.
Contact Intex Service Center. Replace the cell
if needed.
Partially drain the pool and refill it with fresh
water. See “Salt & Pool Water Volumes”.
Household voltage is too high or too low
(+ 20%). Check the voltage is within the range
stated on the device housing.
Contact Intex Service Center.
LED PANEL
CODE
PROBLEM
SOLUTION
LED Panel Code Flash & Alarm On (
NOTE:
Always turn off the power before cleaning and servicing).
IMPORTANT
If you continue to experience difficulty, please contact our Consumer Service Department for
assistance. See separate “Authorized Service Centers” sheet.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intex ECO7111 and is the answer not in the manual?

Intex ECO7111 Specifications

General IconGeneral
BrandIntex
ModelECO7111
CategorySwimming Pool Filter
LanguageEnglish

Related product manuals