Intex ECO7111 - Pool Inlet Valve Setup

SAVE THESE INSTRUCTIONS
Page 2
(249PO) MODEL ECO7111 Cartridge Filter Pump & Saltwater System with E.C.O. ENGLISH 7.5” X 10.3” PANTONE 295U 04/06/2017
English
249
PO
S AVE THESE INSTRUCTIONS
English
Page 9
POOL INLET - NOZZLE & PLUNGER VALVE SETUP (OPTIONAL)
5
2
1
7
1
2
8
INSIDE
LINER WALL
9
WATER
FLOW
POOL
6
23
37
25
INSIDE LINER
WALL
22
36
1.
In a counter-clockwise motion unscrew plunger valve
union from the inlet threaded air connector
(37)
(see drawing 5)
. Be careful not to lose the step
rubber washer
(21)
. Place the plunger valve on the
ground in a safe place.
2.
In a counter-clockwise motion unscrew the strainer
nut
(22)
from the inlet threaded air connector
(37)
.
Leave the flat washer
(23)
on the connector
(37)
.
3.
Install the nozzle and plunger valve at the upper
position of pool inlet. From the inside of the pool
liner insert the nozzle union
(25 & 37)
into one of
the pre-cut holes with the washer remaining on the
connector to be placed against the inside of the liner
wall.
4.
Before assembly, lubricate the threads with a
petroleum jelly. Then, with the flat side of the
strainer nut
(22)
facing the outside wall of the liner
in a clockwise motion screw the strainer nut
(22)
back onto the inlet threaded air connector
(37) (see
drawing 6)
.
5.
Finger tighten the adjustable pool inlet jet nozzle
(25)
and the strainer nut
(22)
onto the inlet threaded air
connector
(37)
.
6.
Grasp the plunger valve assembly. Make sure the
step washer
(21)
is in place.
7.
Screw the air jet valve
(36)
over the inlet threaded air
connector
(37)
.
NOTE:
Make sure the air jet valve is
securely tighten and facing up. In a clockwise motion
screw the plunger valve union back onto the inlet
threaded air connector
(37) (see drawing 7)
.
8.
In a clockwise motion turn the plunger valve handle
to close position. Ensure the plunger valve is
securely closed. This will prevent water from flowing
out during filling of the pool
(see drawing 8)
.
9.
Adjust the direction of the nozzle head pointing away
from the pool outlet for a better circulation result
(see
drawing 9)
.
10.
The pool liner is now ready to be filled with water.
Consult the above-ground-pool owner’s manual for
the filling instructions.