(38IO) I638AA AIRBED ENGLISH 4.875” X 7.25” 07/28/2020
38IO
SAVE THESE INSTRUCTIONS
Page 4
INFLATION
USING THE ELECTRIC AIR PUMP AND TOP OFF THE FIRMNESS WITH THE BUILT-IN
PRESSURE ADJUSTER
NOTE: The electric pump is a low pressure inflator. Start by inflating the airbed using the
electric air pump until the sides are up and then use the built-in pressure adjuster to reach
your desired firmness.
1. Make sure the manual inflation port cap (4) on the electric air pump cover (3) is closed by
pushing in firmly. See Fig (5).
2. Open the electric air pump cover (3) and turn the switch ON to inflate the airbed until the
airbed side walls are up.
See Fig (6). The airbed will take shape but still feel soft
.
3. To switch off the pump, simply close and latch the electric pump cover (3) and the pump
will stop. See Fig (7).
IMPORTANT: Do not just turn the switch OFF with your finger as this will allow the air
to escape. Close the large electric air pump cover while the pump is still operating to
switch OFF.
4. To achieve the desired firmness, flip the airbed over with the flocked side facing down.
5. Locate the built-in pressure adjuster, unscrew the cap (8) and remove the insert plug (7).
See Fig (8).
8
5 6
7
To Next Page
Loading...
Need help?
General
