(38IO) I638AA AIRBED ENGLISH 4.875” X 7.25” 07/28/2020
38IO
SAVE THESE INSTRUCTIONS
Page 5
6. Top off with hands or foot, whichever is more convenient. Place your hands or foot
directly over the pressure adjuster valve opening, covering the opening completely, and
press down firmly. This will push air from the air pump chamber into the bed. See Fig (9).
MANUAL INFLATION OPTION
A conventional external foot, manual or electric operated air pump (not included) can be
used by connecting it to the manual inflation port located on the electric air pump cover (3).
See Fig (11). Follow these steps:
1. Make sure the built-in pressure adjuster insert plug
(7) and cap (8) are securely closed.
2. Make sure the electric air pump cover (3) is latched
closed. To prevent misplacing or damage to the
electric air pump (2), the pump should be properly
attached.
3. Remove the cap from the manual inflation port (4)
and insert the nozzle of the pump into the port.
Inflate the airbed to desired firmness.
NOTE: To prevent bursting, do not over inflate or
use high pressure air compressor.
4. Remove nozzle from manual inflation port and
close the cap firmly.
FIG (11)
7. Remove your hands or foot so the air pump chamber will re-fill with air for the next cycle.
See Fig (10).
8. Repeat until the desired firmness is achieved.
9. Replace the built-in pressure adjuster insert plug and cap. Turn the airbed over with the
flocked side facing up.
10
OR
9
OR
To Next Page
Loading...
Need help?
General
