(114UK) ELECTRIC POOL HEATER ENGLISH 4.875” X 7.25” PANTONE 295U 07/30/2020
114
UK
S AVE THESE INSTRUCTIONS
Page 7
1.
Plug RCD into power outlet. Press RESET button on the
RCD plug. Indicator should be "ON". See FIG. 1.
2.
Press T button on the RCD plug. Indicator should be
"OFF". See FIG. 2.
3.
Press RESET button for use. Do not use if test fails.
Contact a qualified electrician to determine cause of
failure.
RESET
T
Fig (1)
RESET
T
Fig (2)
RESET
TEST
RCD OPERATING INSTRUCTIONS
1.
Switch the knob clockwise to the "I" position to turn the
electric pool heater on. See FIG. 3.
2.
The red indicator light on the heater top will light up
indicating heater is operating.
3.
Switch the knob counter-clockwise to the "0" position
to turn the electric pool heater off. See FIG. 4.
NOTE:
Turn off the heater before turning off the filter
pump or entering the pool.
4.
The red indicator light on the heater top will turn off.
SPECIAL NOTES
• Always use a thermometer to test the pool water
temperature before entering or using the pool. If the
thermometer indicated water temperature is over
95 degrees Fahrenheit (35 degrees Celsius), wait until the
indicated water temperature drops below 95 degrees
Fahrenheit (35 degrees Celsius) before using the pool, or
below 82 degrees Fahrenheit (28 degrees Celsius) before
operating the electric pool heater again.
OPERATING INSTRUCTIONS
Fig (3)
Fig (4)
IMPORTANT
NEVER use the pool if indicated water temperature is more than 95 degrees
Fahrenheit (35 degrees Celsius). Do not operate electric pool heater while the
pool is in use or occupied.
To Next Page
Loading...
Need help?
General
