Why are there white flakes in the water of my Intex Krystal Clear QS200 Cleaning Equipment?
White flakes in the water usually indicate excessive calcium hardness. To address this, drain about 20 to 25% of the pool water and add fresh water to decrease the calcium hardness. Also, inspect the electrolytic cell for scale buildup and clean it if necessary.
What to do if there is no LED display on Intex Krystal Clear QS200 Cleaning Equipment?
If there is no LED display on your Intex Cleaning Equipment, first check that the power supply is on. Reset the RCD. If the issue persists, contact the Intex Service Center because a power fuse may have blown. There is no suggested solution for LED failure.
How to fix insufficient chlorine in Intex Krystal Clear QS200?
If you have insufficient chlorine in your Intex Cleaning Equipment, several factors could be the cause. It could be due to insufficient operating hours of the Saltwater System, so increase the daily operating time. The salt level in the pool water might be too low (less than 2000ppm), so check the salt level and adjust as needed. Chlorine loss may occur due to intense sunlight exposure, so use a pool cover when the pool is not in use or when the unit is operating. An increased bather load can also cause this, so increase the daily Saltwater System operating time. The electrolytic cell might be clogged or dirty, so remove it for inspection and clean if necessary. Also, high UV level exposure can cause insufficient chlorine, so cover the pool for 2 days with the device running and then test ...
What to do if LED panel code flashes and alarm is on in Intex Cleaning Equipment?
If the LED panel code is flashing and the alarm is on, there could be several reasons. First, ensure a filter pump with the correct flow rate is attached and operating. Check that the circulation line isn't blocked by removing the black hat-like plugs, clearing the filter cartridge and cell from debris, and releasing trapped air. Also, verify the inlet and outlet hose direction, reversing them if necessary. Scale on the flow sensor pins inside the titanium electrode can cause this, so clean the titanium electrode. Make sure the electrode cord is securely plugged in. Reset both timers on the filter pump and saltwater system to resolve any inner timer conflicts. Remove primary electrolytic cell for inspection and clean it if necessary. Add salt if the salt level is low or there is no salt. A...
Table detailing salt requirements for common non-Intex pools.
Table for cyanuric acid needs for common non-Intex pools.
Table for operating times for common non-Intex pools with cyanuric acid.
Instructions for cleaning the titanium electrode monthly for optimal performance.
Explains LED panel codes and their solutions for common problems.
General| Type | Sand Filter Pump |
|---|---|
| Krystal Clear Sand Filter Pump Model | QS200 |
| Frequency | 60Hz |
| Pump Flow Rate | 2000 GPH |
| Filter Media | Sand |
| Voltage | 115V |
To Next Page
