351
A
S AVE THESE INSTRUCTIONS
(351IO) SPA (JET + BUBBLE) ENGLISH 7.5” X 10.3” PANTONE 295U 04/18/2022
English
Page 22
OPERATION (continued)
Jet Nozzle Adjustment
The amount of water and pressure coming out from the jet nozzles can be adjusted
by turning the jet nozzle rim clockwise (maximum water output), counterclockwise
(low water output) or anything in between.
Closing one or 2 jet nozzles will divert more water pressure to the other jet nozzles.
NOTE:
Keep the spa control panel within 5m (16ft) range of the control base to ensure good
wireless transmission signal.
-
+
Function ON OFF Information shown on LED display alternates between
Remaining fi lter pump time and water temperature
Remaining HST time and water temperature
Remaining HST time and water temperature fi rst. Then
remaining HDT time and water temperature.
Remaining HDT time and water temperature
Water temperature and remaining sanitation time
Water temperature and remaining sanitation time
Due to power limitation the following functions can be activated together at the same time:
Filter Pump Heater Air Bubble Sanitizer Water Jet
XX
XX
X
Note:
= can be activated at the same time; X = cannot be activated at the same time.
To Next Page
Loading...
Need help?
General