Intex SL503 - Operation and Troubleshooting; Operating Instructions; Troubleshooting Guide

309
PO
(309PO) MULTI-COLORED BATTERY OPERATED LED LIGHT FOR INTEX
®
BUBBLE SPA ENGLISH 7.25” X 4.875” 04/25/2018
SAVE THESE INSTRUCTIONS
Operation instructions:
•
Left button:
turns the light ON and OFF, and sets the light in solid color flood mode.
•
Right button:
turns the light ON and OFF, and sets the light in changing-color mode.
Press twice to turn off.
• When the light is on, press and hold any button for 3 seconds to turn off the light.
• After 2 hours of continuous use, the device will automatically switch off to save energy.
Page 4
Troubleshooting guide:
Q.
What should I do if the product does not light up?
A.
1. Check the battery holder to ensure 3 AAA batteries are installed correctly with regard to polarity (+ and -).
2. Check that the battery holder and housing cover are snug (hand tightened).
3. Replace the batteries.
Q.
What should I do if the light emitted by this product is too weak?
A.
1. Clean outside surface of the light housing using a soft damp cloth.
Note:
the light housing is an optical component,
to avoid any scratches do not use any hard or abrasive rag to clean it.
2. Replace all batteries with 3 new AAA batteries.
Q.
What should I do if the light is flashing rapidly?
A.
Replace the batteries.
Press left button Once Twice 3 times 4 times 5 times 6 times
Color
Soft white Green Teal Blue Purple OFF
Left Button
Right Button