SECTION 1— MAINTENANCE GUIDELINES
5 Action
NG
Inspect/Adjust Initially (user or attendant)
Quick-release axles lock properly (see page 26).
Inspect handrims for signs of rough edges or peeling finish.
Inspect for broken spokes.
Wheel/fork assembly has proper tension when castor is spun. Castor should come to
a gradual stop.
Wheel bearings are clean and free of moisture.
Loosen/tighten locknut if wheel wobbles noticeably or binds to a stop
Ensure all castor/wheel/fork/head tube fasteners are secure (see pages 7 & 31).
Wheel brakes do not interfere with tyres when rolling.
Wheel brakes pivot point are free of wear and looseness.
Wheel brakes are easy to engage.
Inspect tyres/castors for flat spots and wear.
Check pneumatic tyres for proper inflation (recommended tyre pressure is listed on
the side wall of the tyre).
Clean quick-release axles with a Teflon
®
lubricant.
Ensure axles are free from dirt, lint, etc.
Ensure roller bearings are free from dirt, lint, etc.
Adjust wheel brakes as tires wear.
Clean and wax all parts.
Clean upholstery and armrests.
Ensure castors are free of debris.
Inspect/Adjust Weekly (User or Attendant)
Wheelchair rolls straight (no excessive drag or pull to one side).
Quick-release axles lock properly (see page 26).
Inspect for broken spokes.
Wheel/fork assembly has proper tension when castor is spun. Castor should come to a
gradual stop.
Inspect tyres/castors for flat spots and wear.
Check pneumatic tyres for proper inflation (recommended tyre pressure is listed on the side
wall of the tyre).
Ensure castors are free of debris.
Inspect/Adjust Monthly (User or Attendant)
Inspect seat positioning strap for any signs of wear. Ensure buckle latches. Verify hardware
that attaches strap to frame is secure and undamaged. Replace if necessary.
Loosen/tighten locknut if wheel wobbles noticeably or binds to a stop.
To Next Page