Action
NG 6
SECTION 1—MAINTENANCE GUIDELINES
Inspect/Adjust Monthly (User or Attendant)
Wheel bearings are clean and free of moisture.
Wheel brakes do not interfere with tyres when rolling.
Wheel brake pivot point are free of wear and looseness.
Ensure all castor/wheel/fork/head tube fasteners are secure (see pages 7 & 31).
Ensure all hardware is tight (see page 7).
Ensure hand grips are secure to backrest canes.
Ensure castors are free of debris.
Inspect/Adjust every six months (Repairer or Dealer)
Wheelchair rolls straight (no excessive drag or pull to one side).
Arms are secure but easy to release and locking systems engage properly.
Adjustable height arms operate and lock securely.
Armrest armpad sits flush against arm tube.
All fasteners on clothing guards are secure.
Seat and/or back upholstery have no rips.
Inspect adjustable angle back attaching hardware is securely tightened.
No excessive side movement or binding when rear wheels are lifted and spun.
Inspect handrims for signs of rough edges or peeling finish.
Inspect tyres/castors for flat spots and wear.
Check pneumatic tyres for proper inflation (recommended tyre pressure is listed on
the side wall of the tyre).
Wheel brake pivot point are free of wear and looseness.
Clean upholstery and armrests.
Sealed bearings and axle nut tension are correct.
Wheel/fork assembly has proper tension when castor is spun. Castor should come to
a gradual stop.
Loosen/tighten locknut if wheel wobbles noticeably or binds to a stop.
Wheel bearings are clean and free of moisture.
Wheel brakes are easy to engage.
Clean quick-release axles with a Teflon lubricant.
Ensure axles are free from dirt, lint, etc.
Ensure roller bearings are free from dirt, lint, etc.
Adjust wheel brakes as tyres wear.
Clean and wax all parts.
Ensure castors are free of debris.
To Next Page