binds to a stop. Torque caster wheel to 25 ft-lb (34 Nm).
Ensure all caster/wheel/fork/headtube fasteners are
secure and not damaged/missing. Torque caster wheel to
to 25 ft-lb (34 Nm). Refer to the service manual for fork
tightening instructions.
Check center mount front riggings for loose fasteners.
Replace /tighten if necessary. Torque to 166 in-lbs (14 ft-
lbs, 18 Nm).
Cables shall be inspected periodically to ensure that they
are routed and secured properly. Periodic inspection is
recommended as it may reveal loose and/or damaged
cables. Re-secure all loose cables and replace by following
the recommendations outlined in the LiNX Controls
System Service Manual.
Ensure proper operation of powered functions (drive,
seating, legrests, etc.).
Inspect gearbox coupling.
Inspect electrical components for signs of corrosion.
Replace if corroded or damaged.
Inspect battery terminals for loose cable connection.
Tighten if necessary.
Ensure swingarm stops are in place and not deteriorated
or damaged. Replace if necessary.
Clean upholstery and armrests.
Clean dirt and lint from axles.
Clean dirt and lint from bearings.
Check that all labels are present and legible.
Replace if necessary.
Ensure clothing guards are secure.
Ensure upholstery does not have any rips or tears.
Ensure armrest pad sits flush against arm tube.
Ensure wheelchair rolls straight (no excessive drag or pull
to one side).
Ensure that the casters are free of debris.
Inspect all fasteners including the back pan, back cane and
angle adjustment fasteners, and the arm support, flip back
and height adjustment fasteners. Ensure fasteners are
securely tightened. Refer to the seating system service
manual for torque specifications and tightening
instructions.
Inspect TRBKTS fasteners and hardware.
Inspect foam handgrips for damage. If damaged, have
74 60101916-A
Invacare® AVIVA™ FX
To Next Page