Invacare RPS350-1 User Manual (English)

Other manuals for Invacare RPS350-1

Owner's Operating And Maintenance Manual21 pages

Questions and Answers:

D
davidwilliamsJul 31, 2025
What to do if Invacare Lifting Systems electric actuator fails to lift when button is pressed?
- L
  Lisa MillerJul 31, 2025
  If the electric actuator on your Invacare Lifting System fails to lift when the button is pressed, there are several potential causes: * A loose hand-control or actuator connector: Check these connections and reconnect them if necessary. * Low battery: Charge the batteries. * Emergency stop button: Rotate the red emergency stop button clockwise until it pops out. * Battery connection: Reconnect the battery to the control box. * Actuator service: Contact your dealer if service is required or the load is too high.
D
dbrownAug 6, 2025
Why Invacare RPS350-1 Lifting Systems lift arms will not lower from the uppermost position?
- S
  Scott RodriguezAug 6, 2025
  The lift arms on Invacare Lifting Systems may not lower from the uppermost position because they require a minimum weight load to descend. Try pulling down slightly on the lift arms to initiate movement.
M
Michael MccartyAug 12, 2025
Why is there unusual noise from Invacare Lifting Systems actuator?
- L
  Lauren HawkinsAug 12, 2025
  An unusual noise from the actuator of your Invacare Lifting System could indicate that the actuator is worn or damaged, or the spindle is bent. In such cases, replace the actuator or contact your dealer for assistance.
P
Patricia TaylorAug 17, 2025
What to do if Invacare Mobility Aid electric actuator fails to lift?
- P
  Paul MyersAug 17, 2025
  If the electric actuator on your Invacare Mobility Aid fails to lift when the button is pressed, check the following: * Ensure hand-control or actuator connectors are not loose. * Make sure the RED emergency stop button is not pressed IN; rotate it CLOCKWISE until it pops out. * Charge the batteries, or reconnect them properly to the control box. * Replace the battery pack if necessary. If these steps don't resolve the issue, the electric actuator may need service or the load might be too high.
C
Cindy BurtonAug 25, 2025
Why Invacare Mobility Aid lift arms will not lower in uppermost position?
- D
  dbrennanAug 25, 2025
  The lift arms on your Invacare Mobility Aid may not lower from the uppermost position because they require a minimum weight load to initiate the descent. To resolve this, pull down slightly on the lift arms.