INDICATIONS
WATER TANK FULL
Indicator turns red when tank is full, removed, or misplaced.
• The water level control switch shuts o the dehumidier when the water
tank is full, removed or misplaced.
AUTO DEFROST
When frost builds up on the evaporator coils, the compressor will cycle o and the fan
will continue to run until the frost disappears. The “Defrost” indicator will then turn on.
• This function not only ensures the safe and appropriate operation of the
dehumidier but is also more ecient and economical in its performance.
7. WATER TANK & DRAIN HOSE
There are two ways to remove collected water. Before proceeding ensure that you have
switched o and unplugged the unit.
When unit is OFF and the tank of the dehumidier is full, the full indicator will be lit
and the display will read P2. Additionally, when the unit is on and the tank is full, the
compressor stops operation followed by the fan a few minutes later. The full indicator
will ash and the display will show P2.
• Slowly remove the bucket. Grip the handle with caution and carefully pull outwards so
the water does not overow. Do not place the tank on the oor because the bottom of
the tank is uneven. Doing so the tank will fall and the water will be spilled on the oor.
• Empty the water from the tank and place it again in to the device. The water tank,
must be securely and properly placed, for the dehumidier to operate.
• When the water tank is re-installed the unit will automatically restart.
To Next Page
Loading...
Need help?
General
