5
IDENTIFICATION OF PARTS
Identification of parts
Other features
Bucket Full Light
Glows when the bucket is ready to be
emptied, or when the bucket is removed
or not replaced in the proper position.
Auto Shut Off
The water level control switch shuts off the
dehumidifier when the bucket is full, or when
the bucket is removed or not replaced in the
proper position. When the set humidity level
is reached, the unit will be shut off automatically.
Power Cord
Air Outlet grille
Drain hose outlet (see page 7)
Air filter (behind the air intake grille)
Power Plug
Power cord band (Used only when storing the unit.)
Front
Rear
Control panel
Air intake grille
Water bucket
Handle
Fig.1
Fig.2
Wait 3 minutes before resuming operation
After the unit has stopped, it will not restart operation
for three minutes. This is to protect the unit.
Operation will automatically start after 3 minutes.
NOTE: All the pictures in the manual are
for explanation purposes only.Your unit
may be slightly different. The actual shape
of the unit you purchased may be slightly
different, but the operations and functions
are the same.
When frost builds up on the evaporator coils, the
compressor will cycle off and the fan will continue
to run until the frost disappears.
Auto Defrost
Auto-Restart
If the unit turns off unexpectedly due to a power outage, it will
restart with the previously set functions automatically when the
power resumes.
Setting the Timer
When the unit is on, press the Timer button to actieve the AUTO
STOP featrue. When the unit is off, press this button to actieve the
AUTO START feature.
Press or hold the UP or DOWN button to change the Auto time by
0.5 hour increments, up to 10 hours, then at 1 hour increments up to
24 hours. The control will count down the time remaining until start.
The selected time will register in 5 seconds and the system will
automatically revert back to display the previous humidity setting.
Turning the unit ON or OFF at any time or adjusting the timer setting
to 0.0 will cancel the Auto Start or Auto Stop feature.
When the LED display window displays the code of P2, the Auto
Start or Auto Stop feature will also be cancelled.
To Next Page
Loading...
Need help?
General
